Carpet installers lay carpet in homes, offices, restaurants, and many other types of buildings. Show Details
Carpet installers typically do the following:
Remove old carpet or flooring to prepare surfaces for laying new carpet
Inspect the condition of the surface to be covered
Fix any problems that could show through the carpet or cause uneven wear
Measure the area to be carpeted
Plan the layout of carpeting to get the best appearance and least wear
Install a padded cushion underneath the carpet
Roll out, measure, mark, and cut the carpet
Fit the carpet so that it lays evenly and snugly
Tack, glue, or staple carpeting to hold it in place
Finish the edges so that the carpet looks neat
Carpet installers lay carpet in many types of new and old buildings, including homes, offices, restaurants, and museums. Although installing carpet in newly constructed buildings requires minimal preparation, those who replace existing carpet must first remove old flooring, including any padding, glue, tacks, or staples. In some cases, carpet installers lay carpet over existing tile or hardwood.
Carpet installers work with special tools, including a "knee kicker" to position the carpet and a power stretcher to pull the carpet snugly against walls. When they have to join seams of carpet (for example, in large rooms), they use special heat-activated tape. In commercial installations, they may glue the carpet to the floor or to padding that they have glued to the floor. On steps, they may use staples to hold the carpet in place. They also use carpet knives, carpet shears (scissors), hammers, power sanders, and other tools.
Tile and marble setters apply hard tile, marble, and wood tiles to walls, floors, and other surfaces. Show Details
Tile and marble setters typically do the following:
Clean and level the surface to be tiled
Measure and cut tile and marble
Arrange tiles according to the design plans
Prepare and apply mortar or other adhesives
Install tile and marble in the planned area
Apply grout with a rubber trowel
Wipe off excess grout and apply necessary finishes, such as sealants
Tile installers, tilesetters, and marble setters install materials on a variety of surfaces, such as floors, walls, ceilings, countertops, patios, and roof decks. Because tile and marble must be set on smooth, even surfaces, installers often must level the surface to be tiled with a layer of mortar or plywood. If the area to be tiled is unstable, workers must nail a support of metal mesh or tile backer board to create a stable surface.
To cut tiles, workers use power wet saws, tile scribes, or hand-held tile cutters to create even edges. They use trowels of different sizes to spread mortar or a sticky paste, called mastic, evenly on the surface to be tiled. To minimize imperfections and keep rows straight and even, they put spacers between tiles. The spacers keep tiles the same distance from each other until the mortar is dry. After the mortar dries and the tiles are set, they apply grout between tiles using a rubber trowel (called a float).
Marble setters may cut marble to a specified size with a power wet saw. After putting the marble in place, marble setters polish the marble to a high luster, using power or hand sanders.